west point
Engineer
Roanoke - Bristol - Knoxville - Chattanooga several problems.
1. Roanoke - Bristol very low population base. N&W stopped at many places to get very few passengers.
2. Bristol - Would need to add Johnson City with East Tennessee State University. Kingsport not on proper route but many persons. Passenger service only a single Clinchfield RR train stopped shortly after WW-2. This whole Tri-cities area has 500,000+ population.
3. Bristol - Knoxville best RR time was ~ 3:45 that was still faster than US 11E or US 11w. Time might improve because there was always a lot of head end traffic on the SOU - N&W - SOU trains. RPO discontinuance quickly caused trains to be cancelled.
4. Knoxville - Chattanooga many possible stops slowing down service.
5. Chattanooga - Atlanta requires 25 mile backtrack to Ooltewah on NS or 15 mile back track on CSX. Both CSX & NS go Chattanooga - Dalton, Ga with about same passenger running times.
Note: Have lived in area and much information from old timers.
1. Roanoke - Bristol very low population base. N&W stopped at many places to get very few passengers.
2. Bristol - Would need to add Johnson City with East Tennessee State University. Kingsport not on proper route but many persons. Passenger service only a single Clinchfield RR train stopped shortly after WW-2. This whole Tri-cities area has 500,000+ population.
3. Bristol - Knoxville best RR time was ~ 3:45 that was still faster than US 11E or US 11w. Time might improve because there was always a lot of head end traffic on the SOU - N&W - SOU trains. RPO discontinuance quickly caused trains to be cancelled.
4. Knoxville - Chattanooga many possible stops slowing down service.
5. Chattanooga - Atlanta requires 25 mile backtrack to Ooltewah on NS or 15 mile back track on CSX. Both CSX & NS go Chattanooga - Dalton, Ga with about same passenger running times.
Note: Have lived in area and much information from old timers.
Last edited by a moderator: