I have been traveling that stretch all my life and I don't think I have ever seen it not having some sort of major maintenance being done and all four tracks open.
No professional training, but my understanding is that the euro rules for cant def allow for higher deficiency than the FRA does in the US in similar track scenarios, and there isn't an obvious reason for that differenceBased on any actual professional training, or just a gut feeling?
Even if you solve that, I think that the track centers are too close together to enable tilting for any actual high speed operation.
Also extra height cars. I suspect FRA would allow higher cant deficiency in segregated passenger lines where freight trains are not permitted but that precludes doing so on most of NEC.ehh heavier freight cars in US ?
The problem at Walk is that the swing bridge is being replaced with 2 separate lift bridges. That requires tracks 1 and 3 to be moved approximately 15 feet to the north. That allows tower support columns be installed between tracks 1 & 2 for the support columns. So initially track 1 will be cut for the column with 3 being the thru route.I have been traveling that stretch all my life and I don't think I have ever seen it not having some sort of major maintenance being done and all four tracks open.
And there are more bridges between Greenwich and New Haven that will need work in the next two decades to keep the trains running.The problem at Walk is that the swing bridge is being replaced with 2 separate lift bridges. That requires tracks 1 and 3 to be moved approximately 15 feet to the north. That allows tower support columns be installed between tracks 1 & 2 for the support columns. So initially track 1 will be cut for the column with 3 being the thru route.
Then 1 will be moved north to cross the swing bridge's outer track (3). After the north lift bridge is complete both 1 & 3 will be aligned and altitude somewhat raised to cross the lift bridge.
The repeat for tracks 2 & 4 with them moved south to allow for new support column next to north lift bridge's support column. All this while keeping all construction clear of snagging anything on the swing bridge. Everything on the new lift bridges constructions has to not interfeer with operation of swing bridge. That is one reason that the new track alignment will be higher elevation than swing bridge.crossing.
CONFUSED ???
That is quite true. Have lost count but there are at least 4 more to replace. Some with dual lift bridges and some with dual Bascule bridges. Each bridge that can be raised to give more clear freeboard when in closed position means fewer openings. Even Brightline is doing that.And there are more bridges between Greenwich and New Haven that will need work in the next two decades to keep the trains running.
The really hard one to fix is COB in Greenwich. This is on the most heavily used trackage for the New Haven line and also there will be angry rich boaters to protest any restrictions on use of the channel. And the NIMBY, BANANA, and environmental crazies will be out in full force.
That will only affect a few miles before the particular bridge being reconstructed until the next crossover after the bridge. Or is every single bridge between New Rochelle and New Haven going to be restricted to 2 tracks for the next 28 years?There will not be 4 unimpedied tracks New Rochelle <> New haven until at least year 2050. All the moveable bridges being replaced are going to restrict MNRR tracks to 3 and for short times of 2 - 3 months will be just 2 tracks across the moveable bridge location. That is for the new north lift bridge. Walk bridge is now just 3 tracks and will be just 2 sometime late 2023 or 2024. Then starts over when building the south lift bridge..
The embedded video is very good.Nice article in WaPo on Avelia Liberty
https://www.washingtonpost.com/transportation/2022/09/22/amtrak-acela-high-speed-trains/
I think CAHSR has proved that incorrect, FRA is super conservative and seems unlikely to change in the near term. While the geometry is built to US standards for 250mph, in Europe that would be fine for closer to 300mph.Also extra height cars. I suspect FRA would allow higher cant deficiency in segregated passenger lines where freight trains are not permitted but that precludes doing so on most of NEC.
compare to Shinkansen which allows superelevation 7in upto 7 7/8in (not clear when) and 4 3/8in of unbanaced which allows a combine 11.4-12.2inI have not been following what is happening with cant deficiency on California HSR. How much is the maximum being used?
Thanks for that. The Acela and Regional/Commuter trains videos were taken at the Newark, DE station.The embedded video is very good.
Here is a link to the same article, with no paywall for 14 days:
https://wapo.st/3qW4Jps
If there was just one bridge track shut down delays would not be too disrupting. However there will be unplanned delays that will muck up especially if they come in between the CPs either side of bridge replacements.That will only affect a few miles before the particular bridge being reconstructed until the next crossover after the bridge. Or is every single bridge between New Rochelle and New Haven going to be restricted to 2 tracks for the next 28 years?
Giving a government agency the benefit of the doubt is a terrible mistake, they will always be there to hamstring you if they can. FRA is no exception to that and GDRRiley is completely right in using the buff strength/euro rolling stock examples.I think CAHSR has proved that incorrect, FRA is super conservative and seems unlikely to change in the near term. While the geometry is built to US standards for 250mph, in Europe that would be fine for closer to 300mph.
They took years to accept that buff strength was flawed and that CEM was important. Getting euro rolling stock was equally a long fight
I haven’t been able to step foot on one of the new high speeds yet. So I honestly don’t know about it at this point.Since the Avelia Liberty cafe cars lack seating is there a dedicated conductor office or crew compartment? Or will they just rope off revenue seats?
I have no clue so this is a total guess, but I'd assume so. IIRC the current acelas have a little conductor's office in the cafe car, though I could be misremembering.Since the Avelia Liberty cafe cars lack seating is there a dedicated conductor office or crew compartment? Or will they just rope off revenue seats?
Enter your email address to join: